Euroimpianti designs and builds Morris conveyors, which are suitable to carry all different kinds of products, whether small or large size.
So far, Morris overhead conveyors, so-called trolley conveyors, still represent the most suitable and reliable system to carry heavy loads.
These conveyors are made up of a pulling chain which performs a closed circuit by hauling the trolleys that run on a guide which usually made up of an INP profile.
The conveyor runs either on a flat surface, or, if necessary, on slopes that range between 45° and smaller slants. Particular guides are created in the INP profile to guarantee correct movement of the pieces.
In the horizontal level, the chain change of direction is created by means of wheel or side-by-side vertical axis rollers.
As in the other types of conveyors, the minimum move between a trolley and the other, is determined by the load overhaul dimensions in correspondence to the curves and inclination segments.
These steps can be graphically determined during the design phase, in accordance to the dimension of the pieces to be treated.
A motor-driven caterpillar controlled by an inverter, guarantees smooth pulling and constant movement of the chain and of the trolley connected to it. The speed can be easily adjusted from the electrical panel, in accordance with the production capacity to be reached.